Wind blade matching vortex fan cleaning equipment fan

Wind blade matching vortex fan cleaning equipment fan

1.Flat washers and spring washers must be used to tighten screws;
2. Can use rubber buffer rubber to withstand the weight of annular blowers, especially high-power high-pressure blowers,

3. For certain occasions where noise is required, sound-absorbing cotton can be installed to reduce noise (usually around 5dB). The sound-absorbing cotton is installed at the end of the inlet or outlet duct;
For certain situations where high noise requirements are needed, a layer of soundproofing foam can be added based on the machine's own conditions to meet the on-site noise requirements. For specific details, please consult our company.
5. When using sound-absorbing foam, pay attention to the distance between the high-pressure blower and the box, the ventilation and heat dissipation of the blower, and the use of rubber buffer to bear the weight of the annular blower. Please consult our staff for specific details;
6. The inlet and outlet pipes of the high-pressure annular fan should be connected using hoses to isolate vibration.vortexAnWhen the fan reaches normal speed, the input current of the fan should be measured to ensure that it is normal. The operating current of the fan should not exceed its rated current. If the operating current exceeds its rated current, check whether the voltage supplied to the fan is normal.

7. The required motor power for the fan refers to the higher power required for the centrifugal fan and fan case when the air inlet is fully open under certain operating conditions. If the air inlet is fully open for operation, there is a possibility of damage to the motor. When testing the fan, close the valves on the inlet and outlet pipelines of the fan, gradually open the valves after operation until the desired working condition is reached, and pay attention to whether the operating current of the fan exceeds the rated current.

Wind blade matching vortex fan cleaning equipment fan