JX71Z-M18X1.5-90-00 Gearbox Shaft Vibration Sensor

NegotiableUpdate on 02/10

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

JX71Z-M18X1.5-90-00 gearbox shaft vibration sensor is mainly used for vibration monitoring of large rotating machinery such as steam turbines, water turbines, fans, compressors, oxygen concentrators, motors, pumps, gearboxes, etc. The vibration changes caused by reasons such as casing vibration, bearing vibration, rotor imbalance and misalignment, loose parts, damaged rolling bearings, and damaged gears can be measured in real-time.

Product Details

　　JX71Z-M18X1.5-90-00 Gearbox Shaft Vibration Sensor

Introduction:

Vibration sensors, also known as transducers or pickups, are electromechanical conversion devices. Vibration sensors are one of the key components in testing technology and have a wide range of applications in daily life.

A vibration velocity sensor utilizes the principle of magneto electric induction to convert vibration signals into electrical signals. It mainly consists of a magnetic circuit system, inertial mass, spring, and other components. There are fixed magnets and inertial masses in the sensor housing, and when we use spring elements, we can suspend them on the housing. During work, sensors can also be installed on the machine when it generates vibrations. If within the working frequency range of the sensor, the coil and magnet will undergo corresponding relative motion, cutting magnetic field lines, and generating corresponding induced voltage inside the coil, which is proportional to the vibration velocity value. Paired with secondary instruments, it can display the magnitude of vibration velocity or displacement, and also transmit it to other secondary instruments and AC voltmeters for measurement.

　　JX71Z-M18X1.5-90-00 Gearbox Shaft Vibration Sensor

Technical Specifications:

灵敏度： 20mv/mm/s±5% 30mv/mm/s±5%、 50mv/mm/s±5%

Frequency response: 5-1000Hz

Natural frequency: 10Hz

Measurement range: 1. 0-10mm/s 0-20 mm/s 0-50 mm/s

2、0～100um 0～200um 0～500um

Signal output: Standard current of 4-20mA (if not specified by the user, the two-wire system shall prevail at the factory)

Output impedance: ≤ 500 Ω

Power supply: DC24V

**High acceleration: 10g

Installation method: Vertical or horizontal installation on the measured vibration source