How much is a vortex air pump

How much is a vortex air pump

High pressure vortex air pumpWorking Principle:

The impeller of a vortex air pump is composed of dozens of blades, similar to the impeller of a large gas turbine. The air in the middle of the impeller blades is subjected to centrifugal force and moves towards the edge of the impeller, where it enters the annular cavity of the pump body and circulates again in the same way from the starting point of the blades. The circulating airflow generated by the rotation of the impeller leaves the air pump with * energy for use.
1. Special blade design, high pressure, large air volume, low noise, and long service life. 2. High stability of air volume control and easy operation.

3. Complete range of styles. Strong insulation performance, easy installation, high reliability, high compression ratio, low bearing operating temperature, oil-free and pollution-free, easy maintenance, beautiful appearance, , Zui High Quality The generation of high pressure and high suction is due to the design of the impeller. The impeller edge of the vortex air pump has multiple blades. When the impeller rotates, due to centrifugal effect, the air in the two blades is quickly moved towards the outer edge direction, transferring energy. The wind pressure is quickly superimposed, forming high pressure or high force, and its speed is increased. When the air is reintroduced into the impeller by the air duct, it will be accelerated again. Due to the transfer of energy by multiple blades, wind pressure is rapidly superimposed, resulting in high pressure or high suction.

How much is a vortex air pump

Usage and maintenance:

1. The vortex air pump should be placed in a relatively stable place, and the surrounding environment should be clean, dry, and ventilated.

2. The rotation direction of the impeller of the vortex air pump must be in the direction indicated by the arrow on the fan casing.

3，When working, the working pressure should not exceed 8kPa to avoid excessive heat generated by the air pump and motor overcurrent causing damage to the air pump.

4. Except for the two bearings of the motor rotor, there is no direct contact friction in other parts of the vortex air pump. The installation method of bearings for this air pump is mainly divided into two categories. *The bearing at the end of the class air pump is installed in the pump body between the motor base and the impeller, and this type of air pump does not need to be lubricated normally. The bearings on the second type of air pump end are installed in the middle of the pump cover, and the bearings on this type of air pump end should be regularly lubricated with grease (7018 high-speed grease). Once a month, for air pumps that work continuously in three shifts, the refueling frequency should be increased. The maintenance and upkeep of the bearings on the motor and fan end of this type of air pump shall be in accordance with the * type of air pump.

5. The filter screens and silencing devices at both ends of the vortex air pump should be cleaned in a timely manner according to the situation to avoid blockage and affect use.

6，Vortex air pumpThe external connection of the inlet and outlet must be made using flexible hoses (such as rubber hoses, plastic spring hoses).

7. Replacement of bearings for vortex air pump: The replacement of bearings must be carried out by personnel familiar with repair work. First loosen the screws on the pump cover, and then disassemble the parts one by one according to the order shown in the diagram. The disassembled parts should be cleaned, and then assembled in reverse order. When disassembling, do not forcefully pry the impeller, use a roller to remove it, and do not miss the adjusting gasket to avoid affecting the clearance that has been adjusted before leaving the factory.

8，It is strictly prohibited for solids, liquids, and corrosive gases to enter the pump body.