High pressure gas exhaust vortex fan

High pressure gas exhaust vortex fan

Instructions for Use:

1． The air pump must be placed in a dry and ventilated area above the water level.

2． The installation position of the air distribution head must be higher than the water level of the bathtub to prevent water from entering the air pump.

3． The connecting pipe of the air pump must use heat-resistant pipes (greater than100Celsius does not deform.

4． The air pump must be fixedly installed, and the connecting pipe must be tightly wound.

5． To prevent electric shock accidents, the air pump must be reliably grounded.

6． Do not block the operation of the air outlet. If the air volume is too small, the air temperature will rise. Be careful to prevent burns. When checking the air pump, the power supply must be disconnected.

Product advantages

1. Low noise and quiet operation.

2. The pump cover has vacuum sealing and good waterproof performance.

3. Strong suction capacity and large capacity for dirt in the isolator.

4. The main components of the water pump are made of special plastics that are resistant to high and low temperatures, and are durable and long-lasting.

5. Easy to operate, easy to maintain, and supplied with spare parts.

High pressure gas exhaust vortex fan

Use and maintenance

1. The air pump should be placed in a relatively stable place, and the surrounding environment should be clean, dry, and well ventilated.

2. The rotation direction of the air pump impeller must be in the direction indicated by the arrow on the fan casing.

3. When the air pump is working, it should be avoided that the inlet and outlet of the fan are sealed to prevent excessive heat generation and motor overcurrent that may cause damage to the air pump.

4. Except for the two bearings of the motor rotor, there is no direct contact friction in other parts of the air pump. The installation method of bearings for this air pump is mainly divided into two categories. *The bearing at the end of the class air pump is installed in the pump body between the motor base and the impeller, and this type of air pump does not need to be lubricated normally. The bearings on the second type of air pump end are installed in the middle of the pump cover, and the bearings on this type of air pump end should be regularly lubricated with grease (7018 high-speed grease). Once a month, for air pumps that work continuously in three shifts, the refueling frequency should be increased. The maintenance and upkeep of the bearings on the motor and fan end of this type of air pump shall be in accordance with the * type of air pump.