Burkert brass electric control valve

NegotiableUpdate on 02/17

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Burkert brass electric control valve $r $n $r $n is suitable for high medium throughput $r $n direct acting type under low input pressure, and closes $r $n0-0.1bar $r $nDN 12 mm $r $n3/4 "when there is no flow

Product Details

Burkert brass electric control valve

6024 proportional solenoid valve brass G3/4 inch * 2/2 normally closed, FKM sealed, brass valve body, 24VDC

Item number 222551.

Burkert Baodi Baode 6024 proportional valve 00222551, two normally closed types, diameter 12mm, sealed FKM, brass valve body, internal thread G3/4, voltage 24VDC, pressure 0-0.1bar, medium temperature 0-90 degrees, coil receives PWM pulse width signal, converted from 4-20mA analog signal to PWM pulse width by 8605 controller, and adjusts the opening ratio according to the pulse width. Precautions for power connection and wiring. Debug input and output on 8605, select the corresponding proportional valve,

A proportional control valve is a type of control valve that continuously and proportionally controls the flow, pressure, and direction of a hydraulic system based on input electrical signals. Its output flow and pressure are not affected by load changes.

Compared with ordinary hydraulic components, proportional valves have the following characteristics:

(1) Electrical signals are easy to transmit and can be easily controlled over long distances.

(2) It can continuously and proportionally control the pressure and flow of the hydraulic system, achieve control over the position, speed, and force of the actuator, and reduce the impact during pressure changes.

(3) Reduced the number of components and simplified the oil circuit

Burkert brass electric control valveKey points for installation and maintenance

Installation direction

It is usually required to install vertically to ensure that the valve core can move freely.
To avoid medium backflow, install a one-way valve if necessary.

electrical connection

Use shielded cables to reduce interference and ground in accordance with regulations.
Avoid strong electromagnetic field environments (such as near large motors).

regular maintenance

Check the wear of seals and replace aging parts every 6-12 months.
Clean the impurities inside the valve to prevent blockage.