Original SMC standard cylinder with magnetic switch

Original SMC standard cylinder with magnetic switch

Original SMC standard cylinder MDBF100TN-100Z-M9BW

MB-Z series cylinder/standard single rod double acting

Due to the change in cylinder head shape, the weight has been significantly reduced by 10%

● The model of the pole end installation or swing foot seat installation has been set (saving the time of ordering the cylinder and support separately)

● Equipped with magnetic switch (MDB-Z series: MDB, MDBW, MDBK, MDBKW, MDBB, MDB □ Q)

Built in magnetic ringDBuilt in magnetic ring

Installation methodFRod side flange type

bore100Cylinder diameter 100mm

Types of threaded connectionsTNNPT

cylinder stroke100Cylinder stroke 100mm

Cylinder tracking number-No protective cover, air cushion

Travel adjustment markers-none

Dual trip marking-No itinerary markers

Cylinder stroke 2-No cylinder stroke 2

Cylinder tracking number 2-No protective cover, air cushion

Appendix 1-none

Appendix 2-none

Magnetic switch modelM9BW2-color display, contactless magnetic switch, direct output type, with indicator light, 2-wire type, horizontal output, wire length of 0.5m, applicable voltage: DC24V (DC10~28V)

Number of magnetic switches-2 or none

Customized specificationsXC7The material of the pull rod, buffer valve, pull rod nut, etc. is stainless steel sample

Pipe diameter1/2

Applicable fluidsair

formPneumatic type

mode of actiondouble-acting

Rod end shapeexternal thread

Rod end external thread sizeM26X1.5

Low operating pressure [MPa]0.05 MPa

High usage pressure [MPa]1.0 MPa

Ensure pressure resistance [MPa]1.5 MPa

Failure mode of SMC cylinder in Japan: piston stuck and not moving; The cylinder is weak, the sealing ring is worn, and there is air leakage.

The composition of SMC cylinders in Japan:

Japanese SMC cylinders are mainly composed of cylinder body, piston, sealing ring, and magnetic ring (including Japanese SMC cylinders). Taking the single piston rod double acting cylinder commonly used in pneumatic systems as an example,

The typical structure of the cylinder is shown in Figure 1. It consists of a cylinder barrel, piston, piston rod, front end cover, rear end cover, and sealing components. The interior of the double acting cylinder is divided into two chambers by the piston. There is a piston rod chamber

It is called a rodless cavity, and a rodless cavity is called a rodless cavity.

Instructions for using SMC cylinders in Japan

Working medium: Dry and clean air that has been dehydrated, filtered, and contains oil mist.

Medium and environmental temperature: 5-60 ° C Compressed air below 50 ° C requires special dehydration treatment.

Relative humidity: ≤ 85%

Common working pressure range: 0.1~1.0MPa

参考速度: 250mm/s(毫米秒)

Storage: The cylinder should be placed in a ventilated and dry warehouse to prevent moisture and rust.

Before installation, it should be tested under no-load conditions and can only be installed after it is normal.

MB1 single rod double action

Improved version of the double rod double acting air cushion CA1. The cylinder head and cylinder head are connected by four pull rods, and the pull rods do not extend outside the end cover. Beautiful appearance. The machining accuracy of the guide sleeve and piston rod is high, and the sagging of the piston rod is small. High installation accuracy. Buffer chamber addition

Large, with the use of a new buffer seal ring, the buffering capacity has increased by 30% compared to CA1. Capable of high-speed driving. The buffer valve is not exposed outside the cylinder head, safe and easy to adjust. The port and buffer valve are on the same plane.

MB1 is a square section SMC cylinder with four pull rods that are not exposed, and the magnetic switch can be installed in the grooves on all four sides.

Original SMC standard cylinder with magnetic switch