Three coordinate fully automatic probe and measuring seat PH10T/TP2O

Renishaw three coordinate measuring head: advantages of automatic rotation measuring head:
Increase the flexibility of measurement
Convenient for measuring any part of the workpiece
Repeated positioning of the probe in any direction
Can reduce the exchange of measuring needles
Increase the rigidity of the measuring needle to achieve optimal measurement results
Reduce costs
Dividing positioning is faster than replacing measuring needles
Less expensive than active scanning systems
Reduce the cost of measuring needles
Programming is simple

Renishaw PH10T automatic rotating probe holder
Product Overview:
Renishaw PH10TIt belongs to the universal indexing measuring seat. It can achieve repeated positioning of 720 positions, thus completing the detection of any workpiece feature. All M8 threaded probes can be directly installed on the M8 threaded holes of PH10T itself. PH10T is an extension of the PH10 series test bench, using the PHC 10-2 controller and compatible with many other RENSHAW products.
-Compatible with all M8 thread probes
-Compatible with series extension rods up to 300mm in length
-720 repeatable locations
-Carry at 7.5 degrees, with the spindle fixed.
Repositioning accuracy<0.50 μ m (probe length=48.00mm)
Theoretical step spacing accuracy ± 0.24mm (when using TP6 probe and A-5000-3553 probe)
7.50 ° rotation time 2.50 seconds
Full rotation time 3.50 seconds
Rotate in the A (vertical) direction by 0.00 ° to 105.00 ° (with an interval of 7.50 °)
Rotate in the B (horizontal) direction by 0.00 ° to ± 180.00 ° (with an interval of 7.50 °)
Maximum output torque 0.45Nm
720 spatial repositioning directions
Maximum output torque 0.45Nm
Normal operating temperature range: 10.00 ℃~40.00 ℃ (50.00 ℉~104.00 ℉)
Can support a maximum probe length of 300.00mm (11.81 in)
Weight 645.00g
The lower end can be directly connected to an extension rod that can be used with accessories: PEL;
Can be directly connected for use