Initial adhesion testerIf you do not pay attention to maintenance during use, it will have an impact on your safety and efficiency, so it is important to do a good job of maintenance and upkeep during use. Let's take a look below:
Initial adhesion testerHow to maintain. Firstly, it is necessary to ensure the cleanliness of the machine and regularly sweep the dust; Check whether the current of the power interface is normal and whether there is any leakage during each use; Pay attention to the condition of the indicator light when starting up, the indicator light will light up after starting up; Be sure to cut off the power before and after each use to prevent circuit aging.
Initial adhesion testerAfter work, if the alarm sounds, the power should be cut off in a timely manner and sent to the factory for maintenance. Do not continue to use it to prevent life-threatening situations; Do not allow unrelated personnel to approach or operate during use to avoid accidents; Pay attention to waterproofing and do not let the machine come into contact with water. If it is spilled with water, be sure to cut off the power, use a hair dryer to dry it, and then let it air vent for a while; Wear operating gloves and place an insulated rubber pad at the bottom of the tester during operation.
aboveInitial adhesion testerThe maintenance method of the tool is something you need to understand. If you can master the following knowledge, then your process of using the tool will definitely be smooth and effective.