Burkert6126 Baode rocker arm solenoid valveThe direct acting rocker arm solenoid valve 6126 is suitable for general applications that require the connection of compressed air, gas, or slightly dirty liquids.
The medium only comes into contact with the shell material and FKM seal. The amount of heat injected into the medium is minimal, as it has already been transferred through a stainless steel plate
The shell and coil are separated from each other. Valves can be directly connected using flanges, or unit or multiple connection plates can be installed directly. This type of valve can be used for measuring, injecting, mixing, and distributing small amounts of media. Order number for Baode 6126 solenoid valve: 00139151, 00139088, 00139236, 00139154, 00139155
00139158, 00139159, 00139237, 00139162, 00139163

The technical parameters of Burkert6126 Baode rocker arm solenoid valve are shown in the following figure:Technical data
Orifi ce [mm] DN 0.8-1.6 (see ordering diagram for details)
Base material PPS
Sealing material FKM, EPDM rubber
Resistant mediators to neutral liquids and gases (see Burkert Chemicals)
Resistance meter)
Media temperature -10-55 ° C (1)
The maximum value of environmental temperature. 55°C
Viscosity Max. 2/S 21mm
Internal volume
with backing plate
as required
From 44 μ l
< 10μl 2)
Port connection to Burkert sub base (16 x 27 mm)
Cable plug type 2505
ACC label connector. DIN 43650c cable plug
Above type 2506
2 . Flying lead wire, AWG24,lenght 500mm 3)
Operating voltage of 12 and 24V/DC; Other voltage requirements
Voltage tolerance ± 10%
Electricity consumption 3.4 W
The continuous rated value of the working cycle is*
Install as required, perpendicular to the actuator
Protection level is IP65, with cable connecting wires or cable plugs
IP40 with rectangular plug
response time
open
Close
acc。 ISO 12238:2001; Measure at the outlet of the 2 bar valve
+ 20ºC
About 25 ms (pressure range 0-10%)
About 25 ms (pressure range 100-90%)

Burkert6126 Baode rocker arm solenoid valveThese valves can be installed directly or in a single or manifold installation. Use them for quantifying, mixing, blending, and dispersing large quantities of media.